• Lightweight and compact
• Shaft hole diameter : 14mm
• Using a shaft sleeve allows accepting a shaft of 6mm, 8mm, 10mm or 12mm diameter
• The locking lever (on request) prevents the shaft from rotating due to vibrations from the machine (SKP-04 Clamp Plates can also be used for the same purpose).
• Displayed figure height : 6mm
• Comes with a rubber cushion
• Working temperature : Up to 80ºC
• Ensure that the start-up revolution speed is 1/3 or less of the allowable revolution speed.
• Do not give rapid acceleration or sudden stop
• These position indicators can not be used in applications where the shaft moves in the axial direction.
• The rubber cushion and the housing seal (SDO-04-HS) can not be used together.
1. Stick the rubber cushion to the back of the indicator.
Do not stick it when using the housing seal.
2. Drill a fixing-pin hole in the mounting wall, 22m above the shaft center.
3. Slide the indicator onto the shaft to the mounting wall and then tighten the setscrew.
Housing Seal & Front Seal
(to be ordered separately)